Black plate (436,1)

Scheduled Maintenance (U.S.A., Canada, and Puerto Rico)

Follow Schedule 1 if the vehicl e is operated mainly where none of the follow ing conditions

(severe driving conditions) apply.

l

Repeated short-distance driving

l

Driving in dusty conditions

l

Extended periods of idling or low-speed operation

l

Driving for long periods in cold temperatures or extremely humid climates

l

Driving in extremely hot conditions

l

Driving in mountainous condition s continuall y

If any do apply, follow Schedule 2. (Puerto Rico and Canada residents follow Schedule 2.)

Engine oil flexible maintenance is available for U.S.A. and Puerto Rico residents whose

vehicle is operated mainly where none of the following conditions apply.

The onboard computer in your vehicle calculates the remaining oil life based on engine

operating conditions when selec ting flexible maintenance. Mazda Genuine 0W-20 Oil and

Castrol

®

0W-20 Oil are required to achieve optimum calculation performance.

NOTE

After the prescribed period, continue to follow the described maintenance at the recommended

intervals.

6-4

Black plate (437,1)

Replace at first 192,000 km (120,000 miles) or 10 years; after

that, every 96,000 km (60,000 miles) or 5 years.

Replace when any equivalent timing of replacing engine oil.

(Max interval:36 months/60,000 km (37,500 miles))

IIII

IIII

Black plate (438,1)

AIR CONDITIONER SYSTEM

Cabin air filter

Replace when any equivalent timing of replacing engine oil.

(Max interval:24 months/48,000 km (30,000 miles))

I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary.

cause serious damage to the engine and cooling system.

*3 According to state/provincial and federal regulations, failure to perform maintenance on these items will not

void your emissions warranties. However, Mazda recommends that all maintenance services be performed at

the recommended time or mileage/kilometer period to ensure long-term reliability.

*4 The Tire Pressure Monitoring System (TPMS) initialization must be performed so that the system operates

normally (if equipped).

*5 If the vehicle is operated primarily under any of the following conditions, replace the rear differential oil at

every 48,000 km (30,000 miles).

a) Towing a trailer or using a car-top carrier

b) Driving in dusty, sandy or wet conditions

6-6

Black plate (439,1)

II

I

Black plate (440,1)

AIR CONDITIONER SYSTEM

6-8

Black plate (441,1)

Black plate (442,1)

AIR CONDITIONER SYSTEM

Cabin air filter Replace every 40,000 km (25,000 miles) or 2 years.

If any do apply, follow fixed maintenance.

The engine oil and filter must be changed at least once a year or within 16,000 km (10,000 miles) since last

engine oil and filter change. The system must be reset whenever replacing the engine oil regardless of the

message/wrench indicator light display.

*2 Use of FL-22 is recommended when replacing engine coolant. Using engine coolant other than FL-22 may

cause serious damage to the engine and cooling system.

*3 According to state/provincial and federal regulations, failure to perform maintenance on these items will not

a) Towing a trailer or using a car-top carrier

b) Driving in dusty, sandy or wet conditions

c) Extended periods of idling or low speed operation

d) Repeated short trips of less than 16 km (10 miles)

*6 If this component has been submerged in water, the oil should be replaced.

6-10

Black plate (443,1)

Replace at first 192,000 km (120,000 miles) or 10 years; after

that, every 96,000 km (60,000 miles) or 5 years.

Black plate (444,1)

AIR CONDITIONER SYSTEM

Cabin air filter Replace every 40,000 km (25,000 miles) or 2 years.

*2 According to state/provincial and federal regulations, failure to perform maintenance on these items will not

void your emissions warranties. However, Mazda recommends that all maintenance services be performed at

the recommended time or mileage/kilometer period to ensure long-term reliability.

*3 The Tire Pressure Monitoring System (TPMS) initialization must be performed so that the system operates

d) Repeated short trips of less than 16 km (10 miles)

*5 If this component has been submerged in water, the oil should be replaced.

6-12

Black plate (451,1)

Black plate (452,1)

Maintenance Monitor

. Once the system turns on, the wrench indicator

light in the instrument cluster will be illuminated when remaining oil life becomes less than

500 km (300 mile), or remaining days are less than 15 (whichever comes first).

Reset method

Press and hold the TRIP button with the ignition switched off, then switch it on. Keep

pressing the TRIP button for more than 5 seconds. The master warning light will flash for a

few seconds when the reset is completed.

*1 The flexible setting is available in the United States and Puerto Rico. Based on the

1. Select the icon on the home screen to display the “Applications” screen.

2. Select the “Maintenance” to display the maintenance list screen.

6-20

Black plate (453,1)

3. Switch the tab and select the setting item you want to change.

You can customize settings in the setup display as follows:

Select this item to set the maintenance period.

Resets the time and distance to the initial values.

out maintenance.

Displays the distance until tire rotation is due.

Select this item to set the tire rotation distance.

“Tire Rotation Due!” is displayed in red and the wrench indicator

light in the instrument cluster will be illuminated when the

remaining distance is less than 500 km or 250 mile.

Resets the remaining distance to the initial value.

Once the system turns on, it needs to be reset whenever rotating

Puerto Rico. Once engine oil flexible maintenance is selected, the

vehicle calculates the remaining oil life based on the engine

operating conditions. The vehicle lets you know when an oil

change is due by illuminating the wrench indicator light in the

instrument cluster. Mazda Genuine 0W-20 oil and Castrol

0W-20

oil are required to achieve optimum performance.

Displays the engine oil life until the oil replacement is due.

“Oil Change Due!” is displayed in red and the wrench indicator

light in the instrument cluster will be illuminated when the

remaining oil life distance is less than 500 km (300 mile), or

remaining days are less than 15 (whichever comes first).

In flexible setting: Resets the remaining oil life to 100 %.